Nun geht es darum den in der Marlin FW zu aktivieren. * * RAMPS-based boards use SERVO3_PIN.
Dann steht in der Anleitung ich muss den FIL_RUNOUT_PIN definieren. This is my experience in adding a Filament Sensor to my Tevo Tornado. * For other boards you may need to define FIL_RUNOUT_PIN. Once the firmware is configured and uploaded to your printer, Marlin will send M600 gcode to change the filament spool once the sensor is triggered. Marlin Firmware aktueller Stand 1.1.8 (sollte aber auch mit den Versionen 1.1.7 bzw. Search for: * Filament Runout Sensor /** * Filament Runout Sensor * A mechanical or opto endstop is used to check for the presence of filament. * Filament Runout Sensor * A mechanical or opto endstop is used to check for the presence of filament. Die oben genannten Einstellungen müssen unbedingt angepasst werden, anschliessend die Firmware erneut … TEMP_SENSOR_0 1 ; TEMP_SENSOR_1 0 ; TEMP_SENSOR_2 0 ; TEMP_SENSOR_BED 1 ; DEFAULT_AXIS_STEPS_PER_UNIT {80,80,1600,108} // Einstellung für MendelMax 2.5 ; Es lohnt sich, diese Datei mal genauer anzuschauen, sie beinhaltet einige interessante Einstellungen! * For other boards you may need to define FIL_RUNOUT_PIN. Marlin is the firmware used in almost all Desktop 3D printers, especially for printers that are made in China. * By default the firmware assumes HIGH = has filament, LOW = ran out */ #define FILAMENT_RUNOUT_SENSOR Once done, flash the modified firmware to your printer.
Hardware Installation. Hallo, ich habe an meinen Prusa I3 einen Filament Runout Sensor dran gebastelt.
* By default the firmware assumes HIGH = has filament, LOW = ran out */ //#define FILAMENT_RUNOUT_SENSOR #if ENABLED(FILAMENT_RUNOUT_SENSOR) #define FILAMENT_RUNOUT_SENSOR ist klar. Klingt … 1.1.6 funktionieren) In der Datei Configuration_adv.h ab Zeile 1412 sind die … Edit Ikea Lack Table Top Mount design added** This is a mechanical filament sensor which works with every kind of 1.75mm filament. I prefer this endst * * RAMPS-based boards use SERVO3_PIN. More information about the firmware configuration is available at the official Marlin Documentation found here.